Release Film Indentation Guide

Oct 17, 2026

1 Release film is loose

When the release film is installed, it is not fixed tightly or the printing time is too long, resulting in repeated mold removal and extrusion, forming indentations; it is recommended that the customer replace the release film with a new one and re-tighten it

2 There is residual solidified material in the trough

Mainly, during printing, the residual cured resin was not cleaned up in a timely manner, resulting in excessive squeezing of the release film by the secondary printing platform, and the residue punctured the release film;

• It is recommended that customers click the screen clearing button for 20-25 seconds before each print, and then use a black plastic spatula to clean the cured material in the trough;

• After printing 3-4 boards, it is recommended to filter the resin to prevent debris inside from puncturing the release film;

3 There is foreign matter on the surface of the print screen

It is recommended to spray a little alcohol on the printing screen before printing, and then dry it with a lint-free cloth.