Piocreat:What should I do if the luminous characters 3D printer does not output the material when printing?
What is the problem that the
luminous characters 3D printer does not output the material when printing? There must be a reason for this situation. You can check from several angles such as installation of materials, leveling, extruder or extrusion wheel and nozzle. The following are a few solutions compiled by the editor of PioCreat-CreatWit, I hope I can help you.
1. Check if the material is installed in place.
2. Check whether the extruder is jammed during printing. If it is, it means that the nozzle is too close to the platform. Need to re-level.
3. Check if the consumables are not installed in place, try to manually load the material to see if the nozzle is out of wire.
4. If the thread can be produced manually, it means that the extruder may be slipping or not working. Check whether the extrusion wheel is tightly fixed. And check whether the extrusion motor wire is inserted tightly.
5. If the thread cannot be produced manually, the nozzle may be blocked.
It is recommended that customers preheat the nozzle, pass the nozzle opening with a through needle, or replace the nozzle with a new one.